(15 minutes)
Pretty straightforward replacement. Disconnecting the connectors a bit difficult due to age and grime. After cleaning, using a bit of dielectric grease allowed easier assembly of the connectors.
7/13/2024 CHESTERFIELD, MO MIKE
Unrated
(15 minutes)
Very Easy to install on my Kubota BX2350, unplug two wires under the fender, unbolt old unit, run the new wires thru the nut and back through the fender bolt light back on. Took only slightly longer to install than it took to break the original light on my mailbox.
12/8/2023 LANDER, WY James
(10 minutes)
Super simple direct installation. Save the buy and washer from the broken assembly, because the new lamp doesn’t have them. Loosen the wire loom under the fender for easy access to the plugs. Unplug the light from the harness and pull the wiring thru the fender. Loosen the nut and remove the broken lamp. Install in the reverse order.
10/27/2023 Wasilla, AK David
(5 minutes)
I wish everything I had to work on was this easy. Thanks
10/10/2023 SEELEY LAKE, MT Monie
Unrated
(30 minutes)
Except for the wire connection it was easy!!!
9/16/2023 Coloma, MI Randy
(10 minutes)
I accidently broke the hazard light off while mowing too close to some low branches. The new part was identical to the old one so changing it is pretty obvious. One nut to take loose and two wires with different connector shapes makes it as simple as anything I've had to work on on my Kubota Bx2360.
Pretty straightforward replacement. Disconnecting the connectors a bit difficult due to age and grime. After cleaning, using a bit of dielectric grease allowed easier assembly of the connectors.
CHESTERFIELD, MO
MIKE