#K3511-55222 CONTROLLER

(15 minutes)
Pop dash loose with flat screwdriver at 2 tab openings on top of dash and adjust rubber boot of steering wheel to allow dash to be pulled out. Under hood, open metal band that secures speedometer cable to allow dash to move freely and bungee dash up to allow room to access controller. Small ratchet and 10mm socket for bolt removal, unplug old, reinstall new in reverse order and you’re done!

9/5/2025
NEGAUNEE, MI
Sherman

(15 minutes)
Make a bracket that reaches across the bottom so both mounting holes are attached. Kubota sets this part up to fail by only attaching one side. B7800

8/5/2024
PELSOR, AR
Steven

Unrated (2 hours)
(B7800) -Located on a bracket attached to the bonnet under the dash. Kubota installed the controller with a single bolt which contributed to the failure mode. I manufactured a support plate out on .060 aluminum to help support the new controller which also allowed using 2 fasteners for the install. Remove the single screw forward of the steering wheel, remove steering wheel and gromment, (use a puller for the steering wheel) lift the dash straight up approx half inch and move back enough to gain access to electrical connections and tach drive cable. Remove dash assy. I used this opportunity to ring out all the sensors and switches, along with repairing some chaffed wiring, and cleaning electrical connectors. Replaced controller and reassembled. Works great. No more jumping the starter solenoid with a screwdriver.

10/1/2022
LOCUST GROVE, GA
BRIAN