#TD350-55210 SWITCH, CRUISE

(30 minutes)
It worked exactly as described. You have to squeeze the reusable zip tie just right to make it release. My protective cap for the harness was off probably from bouncing down our road. but the product was worked perfectly.

4/15/2023
Ulm, MT
Handu

(5 minutes)
Installed on a Kubota L4060 limited edition. Super easy to install, the wire harness is there under the blank. Just pop the blank out, pull the harness up, plug it in and you’re done.

4/14/2023
GOSHEN, KY
William

Unrated
Installed in my 3560 limited easily and works great. Great upgrade for the cost.

3/3/2023
EL RENO, OK
Mike

(5 minutes)
pop out the blank, wiring harness is right below the opening, pull the wire up through the opening to make it easy to plug in the wire and then just feed the switch in to the opening and snap it in. Done. Plug and play.

8/5/2022
SPRING HILL, FL
Marty

(5 minutes)
This button installs on the Grand L Limited Edition machines to the right of the steering column. All the wiring is already in place. You just pop out the cover on the dash, release the harness from the zip tie, plug in the harness to the back of the switch, and then insert the button into the dash. Super easy and well worth it to be able to set the speed and go when running a mower or similar implement.

7/18/2022
SUMMERVILLE, GA
Bob

(3 minutes)

5/27/2022
MARS, PA
GEORGE

(4 minutes)
It is the only connector under the dash that will fit the cruise control switch. Loosen the zip tie by pinching the connection area, pull out the connector, pop out the protective cover, slide in the cruise switch and plugin. The switch might seem loose in the slot. There is a small metal shield that can be removed on the switch to allow a tighter fit. After I removed that the switch fit snuggly into place.

4/27/2022
LA GRANGE, TN
Jeremy

(6 minutes)
The zip tie that holds the wiring harnesss pigtail for the Cruise control button is held by a reusable zip tie. Just reach up under the dash right below the switch location and you will feel the black zip tie. Just hold back the little tab on the zip ties and release it. Then just feed the pigtail up through the hole and plug into switch. Really very straight forward

3/6/2022
SUGAR HILL, NH
DOUGLAS